ADDAC
ADDAC System Releases ADDAC222 Update – New Firmware, User’s Guide and Signal Flow Diagram
2025
ADDAC222 New Firmware, User’s Guide & Signal Flow Diagram
ADDAC222 a Module with 4×6 Voices 1V/Octave to MIDI Notes. This module allows the conversion of CV signals to a stream of MIDI notes.
ADDAC 222 (part of the MIDI Series) converts 4 CV inputs to four distinct polyphonic MIDI NOTES streams, with up to 6 note voices per input. This allows the user to send midi notes to external midi devices straight from your modular: just plug it into your classic synth or your favorite virtual instruments.
ADDAC 222 Features
- The user can send midi notes to 9 different midi channels (3 BANKS with 3 MIDI CHANNELS each). So, any of the 4 cv inputs may independently send its data to one of these 9 midi channels.
- NOTE OFFs may be sent by pressing the NOTExOFF button or as soon as a trigger is received in the NOTE OFFx cv input.
- A trigger sent to the ALL NOTES OFF cv input (1-4) will remove all the notes at the respective MIDI INPUT.
- The OCTAVES switch (one per INPUT) transposes the notes from +1 to +2 octaves, a rate that can be extended by one more octave using the C1-C2 OFFSET knob.
- The ADJ.x trimmer calibrates the amount of voltage per octave to compensate a possible deviation in the CV IN received signal.
- USB MIDI received data will be routed to the MIDI OUT jack.
- In turn, midi data externally sent to the MIDI IN jack will be routed both to the MIDI OUT jack and the USB MIDI port.
Hello everyone. We’ve been on a Budhist retreat in a cave on the dark side of the Moon for the last two years and literally just returned to Earth today. Did we miss anything whilst we were gone? Anything exciting happen?
Signal Sounds Roundup May 2022
Now that we’re back, fully enlightened and settled in again we’ll endevour to make these mails more regular, keeping it short and sweet and hopefully giving you the best new synths and modules and a few interesting titbits we’ve seen on our travels over the internetz.
Superbooth
Superbooth is the primary source of excitement in the modular and synth world at the moment, taking place in Berlin on Thursday 12th May through to Saturday. Both myself and Aleks will be bothering every one of the 100+ companies exhibiting there to get the lowdown on what new delights they have for us. We’ll do a round up afterwards but the best place to see regular updates would be on our Instagram page.
Ben DivKid continued his mission to bring interesting and affordable modules to the world, His last was with Stead State Fate (the wildly successful RNDStep) and this time around he returns to his first partners, Befacco, to bring us the Stereo Strip.
It’s outrageously good value given that some companies charge more than £200 just for an Audio In and Out module – this one offers that feature (Eurorack or standard Line level, separately selectable for both in and out) PLUS a very high quality Stereo panner and EQ circuit. It’s very funky and not very chunky given that it’s only 6hp. The usual high quality video from Ben (above) is here if you need more convincing.
Look Mum No Computer has been a big figure on YouTube for a long time now and has a repuation for unusual large format 5U modular synths but has now taken those designs and succesfully transplanted them into Eurorack format. The first (of many) module is an all analogue Oscialltor with built in visual Tuner (something rarely seen and since the demise of TipTop’s Z3000…almost impossible to find) and other performance oriented features like Octave Switches. Almost sold out already, move quick if you need to get one.
Non Eurorack Stuff – still lots of interesting stuff happening outside of your rack, look out for some really, really good stuff from Polyend, Moog and Korg in particular and of course the new Dave Smith/Oberheim release, the OB-B8 which we’ll be elbowing people out of the way to get a shot of at the show.
Signal Sounds Shop – if you’ve communicated with us over email in the last year you’ll have heard us moan about how long it’s taken to get the new place fully up and running after out move, however…..we have some final touches being applied to the showroom next week and after that we’ll be in a much better place to make a really inviting and comfortable place to enjoy synths and geek out in. There’s all the Eurorack you can eat plus a cross section of vintage synths, drum machines, mixers and effects to mess with. And a Beer Fridge.
Just a few bits that are in stock now that are worth mentioning
This little lot have show up over the last week or two:
Ben DivKid
Look Mum No Computer
Non Eurorack Stuff
New and Updated Stock
ADDAC112 VC Looper & Granular Sampling
ADDAC System Introduces ADDAC112 VC Looper & Granular Sampling. There’s a long history behind the granular concept and many reinterpretations of its core principles, this is ADDAC System’ take on it. In a loose description digital Granular refer to pieces of sound files being played at the same time with slight or completely different parameters originating what is commonly referred to as granular clouds. Normally there’s a buffer size from which the granular engine snips its pieces and plays them according to the parameters set. This buffer size is normally small in size where grains are so small that can reach the hearing spectrum and be heard as a sort of ever-changing complex wavetable, this is the principle behind granular synthesis.
In the ADDAC System vision, they added the possibility of long buffer sizes up to 5 minutes, allowing “softer” approaches to the granular principle using it as an effect that can generate from “accidental” effects like slight “stutters” to extreme processing and transformation of any incoming audio signal.
This module is conceptually deep but easy to grasp and operate as all controls are in its dedicated panel, all jack inputs and outputs have its own separate panel to allow no compromise when playing its controls.
There are three main sections in this module
- Looper Engine: The Looper is where all the Real-Time recording happens. The audio input feeds the recording buffer, multiple controls allow to record and play loops into a list so that any sample in the list can be accessed at ay time and more acting as a standard looper
- Granular Engine: The Granular acts upon the buffer of whatever LOOP is selected.
- Output Mix: The output mix allows individual control for the Dry Input, Looper Volume, and Grains Volume.
Besides these main sections there’s also a simple strip down MENU mainly used to LOAD and SAVE Banks, no Menu diving guaranteed.
Pricing and Availability
Expected availability: late March
ADDAC System Releases 106 T-Noiseworks Eurorack module
ADDAC System launched a new eurorack module. With the release of ADDAC106 T-Noiseworks the complete the series of T modules. 106 T-Noiseworks is the last in ADDAC’s T-Networks series, a straight forward 4 voice module with frequency and decay controls for each of the voices. As the name already unveils ADDAC added a noise source and created 2 different circuits that explore the timbre of a t-network when used to filter noise.
ADDAC106 T-Noiseworks Features
- 4 Voices each with:
- Frequency control
- Decay control
- Timbre type, Hat/Snare (Voice 1 to 3)
- Frequency Range Switch, Low/Mod/High (Voice 4)
- Input
- Audio Output
There are 2 different circuits in this module, voices 1 to 3 have a pre-vca t-network filter while in voice 4 the t-networks filter applied post-vca.
At each voice input there’s a switch which sets which type of input to use, this signal will be used to control an internal VCA hence why the type of setting defined here is important:
1. Trigger – Any incoming CV will be converted into a 1ms trigger as soon as it crosses it’s fixed threshold.
2. Mute – This disconnects then incoming signal effectivelly muting the voice.
3. Envelopes – This can be used with CV sources as well as Gate sources and simply follows the input signal.
This incoming signal will then be processed by a slew circuit which adds a decay factor allowing the user to set the “Tail” of each voice.
Trigger mode is mostly dedicated for percussive sounds while the Envelope mode is open to any external envelope control and able to control noise swooshes, swirls, crackles and pops simply out of t-networks filtered noise.
Audio inputs are also welcomed to be used as a Trigger/Envelope input, in fact the results of using this method had us all extremelly surprised, so please do try it out!
Diferences between voices:
The first 3 voices also feature a Timbre selector switch: Hat/Snare
In Snare mode all frequencies coming from the t-networks filter pass thru to the output .
In Hat mode it adds a High Pass circuit which removes the mid/bottom frequencies (characteristic of the snare strike) creating a higher spectrum output which is closer to a Hat timbre.
All of these 3 voices are also differently tuned from each other to offer more timbrical options.
Voice 4 is closer to a typical t-networks circuit but this time peculiar one where the noise is gated by the vca and then sent through the t-networks filter.
Hat and Snare are terms used very loosely here, they are timbrical references and do not in any shape or form try to effectively replicate the complex timbres of a real-world Hat or Snare.
-
Microphone2 weeks ago
Unleash Your Inner Podcaster: Discover the Best Microphone for Crisp, Clear Audio
-
Composing2 weeks ago
MUTILATED NOISE by SampleTraxx: The Next Generation Sound Collection
-
Audio Production2 weeks ago
Unleashing Sound Therapy: Incorporating Acoustic Design in a Wellness Centre
-
Vetted6 days ago
15 Best Commercial Vacuums for Efficient Cleaning Solutions
-
Singing2 weeks ago
What Is Breath Support And Why Is It Important For Singers?
-
Ambient2 weeks ago
Unleashing Eerie Waves: A Guide on Producing Dark Ambient Music
-
Ambient2 weeks ago
Mastering the Art of Dark Ambient Synthesizer Music
-
SEO2 weeks ago
Harmonizing Holistic SEO for Musicians: Crafting a Path to Digital Triumph